10. Matters Needing Attention 注意事项
Strictly observes the following needing attention. EEMB will not be responsible for any accident occurred by
handling outside of the precautions in this specification.
您必须严格遵守下述电池使用注意事项。对于没有按照以下注意事项所造成的任何意外事故,EEMB 不
负担任何责任。
! Danger 危险
Use Nickel-plated iron or Nickel-plated stainless steel for the terminals that contact the battery.
使用镀镍铁或镀镍不锈钢作为接触电池的端子。
Make sure that terminal contact pressure is 50g minimum, for a stable contact.
确保端子接触压力最小为 50g,以确保稳定接触。
Keep the battery and contact terminal surfaces clean and free from moisture and foreign matter.
保持电池和接触端子表面清洁,避免受潮和异物进入。
Before inserting the battery, check the battery contact terminals to make sure they are normal, not bent or
damaged. (Bent terminals may not make good contact with the battery or may cause short circuit.)When the
batteries are piled up in a disorderly way, their positive and negative terminals may short-circuit, consuming
some batteries while charging others, causing explosion.
在插入电池之前,请检查电池接触端子,确保它们正常,没有弯曲或损坏。(弯曲的端子可能与电
池没有良好的接触或者可能导致短路。)当电池以无序的方式堆积时,它们的正极和负极可能会短
路,在给其他电池充电时会消耗一些电池,从而导致爆炸。
Lithium batteries that are almost exhausted can output a voltage that is almost the same as that of a new
battery: Please does not judge a battery only with a Voltmeter. Do not mix batteries of different types and
brands, or new and used batteries. We are well informed that battery pack should be assembled with single
batteries of similar voltage, capacity and inner resistance.
几乎耗尽的锂电池可以输出与新电池几乎相同的电压:请不要仅用电压表判断电池。请勿混用不同
类型和品牌的电池,或新旧电池。我们充分了解电池组应使用类似电压,容量和内阻的单个电池组
装。
Lithium batteries need a period of time to recover their normal voltage after even a slight short circuit.
Therefore, if the battery is short-circuited, wait an adequate long time for batteries to recover before
measuring their electrical characteristics.
即使是轻微的短路,锂电池也需要一段时间才能恢复正常电压。因此,如果电池短路,请在测量电
气特性之前等待足够长的时间让电池恢复。
Use a high impedance (1M or higher) voltmeter to measure battery voltage.
使用高阻抗(1M 或更高)电压表测量电池电压。
Add fuse between negative and connector. Once short circuit, it will cut immediately and permanently.
在负极和连接器之间添加保险丝 一旦短路,它将立即永久切断。
Do not contact terminals with conductive i.e. metal, goods. Keep batteries in non-conductive, i.e. plastic,
trays. Reduce impact to insulation layer from vibration, but the dimension will enlarge.
不要接触带导电的端子,即金属,货物。将电池放在不导电的塑料托盘中。减少振动对绝缘层的影
响,但尺寸会增大。
Battery characteristics vary with type and grade, even when batteries are the same size and shape. When
replacing batteries with new ones, be sure to carefully check the symbols and numbers on them.
即使电池尺寸和形状相同,电池特性也会因型号和等级而异。更换新电池时,请务必仔细检查电池