MP Series * SIP SSR * Ratings to 4A @ 280 VAC or 3A @ 60 VDC * Triac (AC) or Transistor (DC) output * DC Control * Normally open (AC or DC) or normally closed output (DC only) * CE Compliant to EN60950-1 PRODUCT SELECTION Control Voltage 3-32 VDC 3A 3A 4A 3A MP120D3 MP240D3 MP240D4 MPDCD3 AVAILABLE OPTIONS AC OUTPUT SPECIFICATIONS (1) Description Operating Voltage (47-63Hz) [Vrms] Transient Overvoltage [Vpk] Maximum Off-State Leakage Current @ Rated Voltage [mArms] Minimum Off-State dv/dt @ Maximum Rated Voltage [V/sec] (2) Maximum Load Current [Arms] Minimum Load Current [Arms] Maximum Surge Current (16.6ms) [Apk] Maximum On-State Voltage Drop @ Rated Current [Vpk] Maximum It for fusing (8.3 msec) [A sec] Minimum Power Factor (with Maximum Load) MP120D3 MP240D3 MP240D4 12-140 400 5 200 3 0.02 90 1.6 36 0.5 24-280 600 5 200 3 0.02 90 1.6 36 0.5 24-280 600 5 200 4 0.02 130 1.6 72 0.5 DC OUTPUT SPECIFICATIONS (1) Description Operating Voltage Range [VDC] Maximum Load Current [Arms] Minimum Load Current [Arms] Maximum Surge Current for 1 second [Adc] Maximum On-State Voltage Drop @ Rated Current [Vpk] Maximum Off-State Leakage Current @ Rated Voltage [mA] MPDCD3 3-60 3 0.02 5 1.5 1.0 INPUT SPECIFICATIONS (1) Description Control Voltage Range Must Turn On Voltage Must Turn Off Voltage Nominal Input Impedance Maximum Turn-On Time [msec] Maximum Turn-Off Time [msec] AC Output DC Output DC Output (-B) 3-32 VDC 3.0 VDC 1.0 VDC 1500 Ohm 1/2 Cycle 1/2 Cycle 3-32 VDC 3.0 VDC 1.0 VDC 1500 Ohm 100 s 100 s 3-32 VDC 1.0 VDC 3.0 VDC 1500 Ohm 100 s 100 s GENERAL SPECIFICATIONS Description Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 VDC) Maximum Capacitance, Input/Output Ambient Operating Temperature Range Ambient Storage Temperature Range Weight (typical) Encapsulation GENERAL NOTES 1) All parameters at 25C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443,13.11.1 3) Inductive loads should be diode suppressed MECHANICAL SPECIFICATIONS Parameters 4000 Vrms 109 Ohm 8 pF -40 to 80C -40 to 125C 0.7 oz. (20g) Thermally Conductive Epoxy WIRING DIAGRAM THERMAL DERATE INFORMATION AGENCY APPROVALS Designed in accordance with the requirements of IEC 62314 EN60950 : Meets the requirements of sections1.5: 1,7: 2.9: 2.10.5.3: 4.2: 4.5: 4.7: E116950 LR81689 (AC Output Only) 5900 UG (AC Output Only) Rev. 071712 ANNEX - ENVIROMENTAL INFORMATION