XICON PASSIVE COMPONENTS • (800) 628-0544
XC-600046 Date Revised: 5/31/17
Characteristics Limits Test Methods ( JIS C 5201-1 )
Direct load
Resistance to a 2.5 kgs direct load for 10 secs.
in the direction of the longitudinal axis of the terminal leads.
Terminal With no evidence of mechanical Twist test :
strength damage. Terminal leads shall be bent through 90° at a point of about
6mm from the body of the resistor and shall be rotated through 360°
about the original axis of the bent terminal in alternating direction
for a total of 3 rotations.
Resistance to Resistance change rate is Permanent resistance change when leads
soldering heat ± (1% + 0.05Ω) Max. with no immersed to 3.2 to 4.8 mm from the body in
evidence of mechanical damage. 260 °C ± 3°C solder for 10 ± 0/-1 seconds
The area covered with a new , smooth
clean , shiny and continuous surface free
Solderability 95 % coverage Min. from concentrated pinholes.
Test temp. of solder : 245°C ± 3°C
Dwell time in solder : 2 ~ 3 seconds
Resistance to No deterioration of protective Specimens shall be immersed in a bath of
solvent coatings and markings. trichroethane completely for 3 minutes with
ultrasonic.
Resistance change after continuous
5 cycles for duty shown below:
Temperature Resistance change rate is Step Temperature Time
cycling ± (1% + 0.05Ω) Max. with no 1 -55°C ±3°C 30 mins
evidence of mechanical damage. 2 Room temp. 10~15 mins
3 +155°C ±2°C 30 mins
4 Room temp. 10~15 mins
Resistance value ∆R/R Resistance change after 1,000 hours
Load life in operating at RCWV with duty cycle of
humidity Normal type ± 1.5 % (1.5 hours "on", 0.5 hour "off") in a humidity
test chamber controlled at 40°C ± 2°C
and 90 to 95 % relative humidity
Resistance value ∆R/R Permanent resistance change after
Load life 1,000 hours operating at RCWV with duty
Normal type ± 1.5 % cycle of ( 1.5 hours "on", 0.5 hour "off" ) at
70°C ± 2°C ambient
CHARACTERISTICS (Cont.)
Specifications are subject to change without notice. No liability or warranty implied by this information. Environmental compliance based on producer documentation.
Metal Film Fixed Resistors (RoHS Compliant) MF-RC Series